Comet CPS 55 ADVANCE BYT Bedienungsanleitung Seite 37

6.8. FILLING, CHECK OF THE FILLING LEVEL
AND DRAINING THE SOLUTION TANK
☞ The temperature of the water or the detergent
should never exceed 50°C
☞ At every filling of the solution tank (Photo 1 - D),
always remember to empty the recovery tank (Photo
3 - C) (see 7.10).
6.8.1. FILLING OF THE SOLUTION WATER TANK
• IThe filling of the solution water tank should NOT
be done with the machine in the raised position.
- Pour into the tank the required quantity of the
chemical product, considering the percentage in-
dicated by the supplier, with reference to the full
tank capacity listed on the product sheet.
• Use only those products suitable for the floor and
the dirt to be removed.
- Pour water in the filling opening placed in the
front of the machine ( Photo 22 - A ).
Leave 2 cm between the filling opening and the liquid
level. Do not fill beyond this point!
B
Photo 22
A) Solution tank filling opening with filter
B) Closing cap
The machine have been designed for the use
•
with non-foaming and biodegradable detergents
made specifically for scrubber-driers.
The use of other chemical products (such as sodium
hypochlorite, oxidizers, solvents or hydrocarbons)
may damage or destroy the machine.
- Follow the safety regulations specified in the rel-
ative section and indicated on the detergent con-
tainer.
- Contact the machine manufacturer to obtain a
complete list of available and suitable detergents.
☞ Always use non-foaming and biodegradable
detergents
- Do not leave the water hose unattended and in-
sert it completely into the tank: the hose might
A
move and get sensitive parts of the machine wet.
- Close the tank with its plug.
6.8.2. DISPLAY OF THE FILLING LEVEL OF THE
SOLUTION WATER TANK
The filling level of the solution water tank can be
viewed through the transparent hose at the rear of
the machine (Photo 23 - A).
B
A
Photo 23
A) Drain hose of the solution tank with level display
B) Plug of the drain hose
6.8.3. DRAINING OF THE SOLUTION WATER
TANK
The emptying of the solution water tank can be made
through the transparent hose on the back of the ma-
chine (Photo 23 - A).
- Disconnect the hose from its holder and place it
next to a container or a sewer drain.
- Remove the cap of the hose (Photo 23 - B) and wait
for the complete emptying of the tank.
- After the draining, close the hose with the cap and
place it in its slot.
37