Installation Information; What To Do In Case Of Trouble - EINHELL CH4000 Bedienungsanleitung

7. Installation information

Observe a safety zone around the heater.
Keep all combustible materials, such as curtains,
wood etc., away from the heater at a distance of
at least 1.5 meters. There is a danger of fire
occurring through overheating.
Set up the heater on a level surface only.
Avoid sloping surfaces or vibrating bases. There
is a danger of fire if the heater falls over.
Do not expose the heater to drafts.
Avoid positioning the heater such that it is
subject to drafts or where people are constantly
passing, since this can give rise to abnormal
combustion.
Do not expose the heater to sunlight
Avoid positioning the heater in direct sunlight or
next to objects that emit considerable heat.
Avoid dusty and damp positions for the
heater
Avoid placing the heater in a damp or dusty
position, since this can lead to dust and
impurities on the air filter or cause other
malfunctions.
Avoid unsuitable positions
Avoid positions where sprays or chemicals are
used e.g. in hairdressing salons, painting
workshops and chemical processing facilities.

8. What to do in case of trouble

Ignition and turning off
Problems
The heater makes a faint noise for
10 seconds after ignition.
White smoke and a smell come from the heater.
The heater does not ignite when
used for the first time.
The flame turns bright red.
Cleaning the heater
Dust should be cleaned from the safety grille of
fan and hot air outlet more than once a week. Th
can be done with a good vacuum cleaner.
Cleaning the oil filter
Turn the oil filter, positioned underneath the tank
towards the left and pull it out. Clean the oil filter
clean fuel. If a lot of dirt has collected on the oil
wipe out the oil inside the fixed tank as well.
N.B.: Impurities and dirt within the tank cause sm
and clogging of the solenoid pump.
Position the oil filter according to the markings o
fixed tank and insert back in by turning it toward
right. ALWAYS CLEAN THE FILTER WHEN YO
REFILL THE TANK.
Extended periods of non-use
Use the hand pump to empty the fuel tank and t
fixed tank in the heater. Wipe the dust from the
heater and store the heater in a well ventilated p
Causes and solutions
This is normal for ignition.
The smell from rust proofing oil or dust when the he
is used for the first time or after extended storage
disappears after 1 – 2 hours operation.
There may be air in the fuel pipe, particularly if the
heater is used for the first time or has been in exten
storage. In some cases there may be recurring nois
Repeat the ignition operation a number of times.
This may happen for the following reasons and is no
problem: The heater burns in salty air close to the s
The heater burns dusty air; The heater burns in a da
atmosphere; The heater is operated close to a runn
air dehumidifier.
G