Automatic Mode; Timer Mode (Switch-On Time); Hour Function - EINHELL CH4000 Bedienungsanleitung

4. Automatic mode

a) Press the "ON" button. You will hear an audio
signal. The display read-out will show [ON].
b) The heater starts automatically after
approximately 2 1/2 minutes warm-up time.
c) The display read-out will show [
d) After approximately 3 minutes the display read-
out [ ] will appear. Only now will the burner
will be burning properly and the automatic mode
be in full operation. The read-out [
continually at various points on the display.
Caution! There may be a faint smell and the
slight emergence of smoke during ignition. This
is normal and is only temporary.
e) The heater will now heat until it is either turned
off with the "OFF" button or until a preselected
temperature level is reached.
f) The temperature is set with the "TIME Control"
buttons.
g) When you press one of the two buttons, the
display will show the following read-out:
current room temperature
required room temperature
Use the "HIGH + LOW" buttons to set the
required temperature [SET]. The current room
temperature "Room C°" is on permanent display.
The sensor for the room temperature is
positioned at the back of the heater, projecting
out at the bottom (Caution! Do not damage!).
N.B.: When you raise or lower the temperature
relative to the current room temperature, the heat
output will be automatically lowered or raised
accordingly. This is indicated on the display
scale as well with [
When you have set the required temperature,
you may choose to reset the display to show the
current time. Simply press one of the two "TIME
Control" buttons.
h) The heater can be turned off completely by
pressing the "OFF" button.
].
] will flash
Room °C
20
SET °C
21
] [ ].
5. Timer mode (preselection of swit
on time)
a) Use the "TIMER" buttons to select the requir
switch-on time – "AM" or "PM".
b) Using the "Temperature Control" buttons, yo
can now set the required temperature as w
Alternatively, you can set the temperature l
instead, after the heater has been started u
automatically.
c) Confirm with the "TIMER Ope. ON" button. T
"TIMER" read-out will flash in the display.
d) The heater starts up automatically at the tim
by you. This can only function, however, if
current time is set.
e) In this mode of operation the heater runs for
hour and then turns itself off automatically.
audio signal will sound before completion o
hour. You can also turn off the heater
beforehand with the "OFF" button.

6. 3-hour function

a) You start up the heater for 3 hours operation
automatically with the "3 HR Ope. ON" butt
The heater turns itself off automatically afte
period.
b) Press the "3 HR Ope. ON" button and the "3
ON" read-out will be shown in the display,
flashing until the heater has been fully start
up. The read-out then remains on permane
display. The ignition operation starts
automatically, as described above.
c) Before completion of the third hour, an audio
signal will sound again and the "3 HR ON"
out will start to flash again.
d) Using the "OFF" button, you may also turn o
heater before completion of the three hours
N.B.: To ensure that no stored heat remains in t
heater, the fan runs for approximately 2 minutes
every turning off operation, regardless of operat
mode.
Display read-outs
VENT + "E 04" read-out in the display.
When this read-out lights up and an audio signa
sounds, the room must be ventilated so that mo
oxygen can be supplied. Press the "OFF" button
After ventilating sufficiently, you can restart the
heater again normally.
G