Technical Data; Preface; Starting Up And Functions - EINHELL CH4000 Bedienungsanleitung

GB
Room temperature control
The room temperature should be comfortable. If it
gets too warm, ventilate the room by opening a
window. Do not manipulate the wick knob. Trying to
reduce the heat by manipulating the wick knob will
only lead to insufficient combustion which may cause
unpleasant odors and health hazards.
KEEP THE OPERATING
INSTRUCTIONS IN A SAFE PLACE!!!

1. TECHNICAL DATA

Model number
Convector type
Filament wattage
Fuel consumption
Daily capacity
Fuel tank
Fuel tank capacity
Ignition
Dimensions
Weight

2. PREFACE

Read the operating instructions carefully. They
contain all the information you need for correct
operation and safe and efficient
set-up of the oil heater. Only a thorough
knowledge of the operating instructions will
allow you to enjoy all the advantages this heater
has to offer.

3. Starting up and functions

Open the lid of the tank and pull out the refill
tank.
Twist off the tank sealing cap and fill the tank
using the hand pump.
Twist the tank sealing cap back on again (be
sure that the thread of the tank sealing cap is not
put on at an angle) and place the refill tank back
in the heater.
18
CH 4000 E
radiant heater
4000 W
183-317 g/h
approx. 12 hours
removable
4.6 liters
electronic
77 x 47 x 59 cm
13.5 kg
Insert the mains plug into a mains socket (2
~ 50 Hz). The time read-out in the display w
flash.
Set the current time using the "TIME Contro
button.
Use the "HOUR" button to set the hour.
Be sure to allow for the "AM + PM" read-out
AM = Morning, 0 – 12 o'clock
PM = Afternoon, 12 – 24 o'clock
Use the "MIN" button to set the minutes.
Use the "TIME Control" buttons to view the
current room temperature "Room °C". You c
use the "High" button to set the required roo
temperature.
Using the "TIMER" button, you can set the
required switch-on time. Your Comfort Heat
then ignites and starts up automatically. In t
TIMER mode of operation the heater switch
again automatically after one hour of operat
The selected switch-on time is activated with
"TIMER Ope. ON" button.
With the "3 HR Ope. ON" button you can ac
three hours of automatic operation.
This function is not connected to the "TIMER
Ope. ON" function.
Use the "ON" button (switched on) to start u
heater.
Use the "OFF" button to turn off the heater.
You can now choose between three options
starting up the heater.