Dmx Operation - EuroLite LED KLS-120 FX Bedienungsanleitung

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 21 control channels.
However, it can also be switched to a mode with 2 or 9 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button so many times until Addr is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 2 CH (2 DMX channels), 9 CH (9 DMX channels) or 21 CH (21 DMX channels).
Use the buttons UP and DOWN to select the desired DMX channel mode. Confirm with the ENTER
button.
3 Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
4 The display will not flash when DMX signals are being received. If no control signals are available, the
display will flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
2-channel mode
Channel
1
Master dimmer
2
Auto and
sound-controlled
programs
All manuals and user guides at all-guides.com
Value Function
000 - 255 Increasing brightness 0 – 100 %
000 – 009 No function
010 – 049 Auto program 1 with increasing speed
050 – 089 Auto program 2 with increasing speed
090 – 129 Auto program 3 with increasing speed
130 – 169 Sound-controlled program 1 with increasing speed
170 – 209 Sound-controlled program 2 with increasing speed
210 – 255 Sound-controlled program 3 with increasing speed
31/36 00128818, Version 1.1