Care Instructions; Maintenance; Backflushing; Exchanging The Filter Medium - Steinbach Classic 310 Originalbetriebsanleitung

4. Check the pump for unusual noises.
If there is air in the system, bleed it again.
5. To stop pump operation, pull the power plug.
The pump is switched off.

Care instructions

The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure hygienically clean
water.
- Consult an expert and observe the dosage.

Maintenance

Backflushing

Do not backwash when using Steinbach Filter Balls. If the filter throughput decreases, we
recommend washing the filter balls by hand. If necessary, exchange the filter balls.
1. Switch the pump
3
2. Connect the backwash line (see section "Connecting the backwash line").
3. Press and hold down the valve lever
4. Set the valve lever to the "BACKWASH" position and release it.
5. Connect the pump's power plug to the power supply.
6. Backwash the system until clean water emerges from the backwash line (max. 2 minutes).
7. Switch the pump
3
8. Press and hold down the valve lever
9. Set the valve lever to the "RINSE" position and release it.
10. Connect the pump's power plug to the power supply.
11. Let the pump run for 20 to 30 seconds to remove any residue in the valve head.
12. Switch the pump
3
The backwashing is completed.

Exchanging the filter medium

The filter medium used (quartz filter sand or Steinbach filter balls) should be exchanged
every 2 to 3 years, depending on the operating period and the amount of dirt on the
device.
1. Switch the pump
3
2. Close the shut-off valves or block the water flow to the pool's connecting hoses.
3. Screw in the drainage opening
4. Completely drain the water from the filter vessel
5. Screw the drainage opening into the filter vessel.
6. Undo the locking ring
purpose.
7. Put aside the locking ring and its screws.
8. Slowly turn the filter vessel on its head and discharge the quartz filter sand or the filter balls.
9. Inside the filter vessel, pull the filter arms
10. Remove the screen.
11. Thoroughly rinse the screen and the filter arms under flowing water.
12. Rinse the filter vessel with clean water.
13. Carry out steps 4 to 12 as described in the "Preparing the filter vessel" section.
The filter medium is exchanged.
off by pulling the power plug.
on the valve head
31
off by pulling the power plug.
on the valve head
31
off by pulling the power plug.
off by pulling the power plug.
so that it comes out of the base of the filter vessel
24
by turning the screw counter-clockwise. Use the Allen wrench
7
off the screen
9
.
1
.
1
via the drainage opening.
2
.
8
.
2
for this
22
39