Filter Shaft; Preparing The Filter Vessel - Steinbach Classic 250N Active Balls+ Originalbetriebsanleitung

Filter shaft

A filter shaft is required if the pool is partially or entirely installed in the
ground so you can place the pump of the filter system below the pool's
water level.
- Make sure that the filter shaft cannot be flooded and that ambient and rainwater can
drain away easily.
You can do so by installing a gravel layer at the bottom of the shaft. An optional
immersion pump with a float switch that is connected to a canal or drain additionally
protects your filter system from rising water inside the shaft.
- Ensure sufficient natural ventilation of the shaft to prevent condensation.
- Design the size of the filter shaft so that you can carry out work on the filter system.

Preparing the filter vessel

1. Undo the locking ring
screw counter-clockwise. Use the Allen
wrench for this purpose.
14
2. Put aside the locking ring and its screws.
3. Mount the drainage screws set
drainage opening
1
Modell:
040385
040386
by turning the
5
on the
8
.
17
C
B
A
A
250 mm
2
B C
525 mm 425 mm
37