hanseatic HGU4582D97710DI Gebrauchsanleitung Seite 73

(e)
4. Insert the two mounting brackets (e) into
the front slots on the top of the dishwash-
er so that you can screw the dishwasher
to the worktop subsequently.
5. Remove the protective films from the side
end profiles (d).
6. Affix the end profiles to the left and right
edges of the dishwasher. This will prevent
a crack being visible between the
dishwasher and the adjacent kitchen
cupboards.
Installation, fitting, connection
7. Push the dishwasher into the recess.
8. To enable the dishwasher to be posi-
tioned levelly, both front and back appli-
ance feet can be adjusted by up to 5 cm.
– Both front feet are equipped with slots.
– You can use the middle adjustment
(d)
9. Check the alignment with a spirit level.
10. Make sure the top edge of the dish-
washer is up to the bottom edge of the
worktop to prevent it from tipping forward
when you open the dishwasher door.
11. Screw the dishwasher to the kitchen unit.
– If you have granite worktops, remove
(28)
Insert a screwdriver into one of the slots
and use it to turn the appliance feet to
the desired height.
screw (28) to adjust the height of the
rear appliance foot. Use a Phillips-tip
screwdriver for this.
(e)
(i)
the internal side cover caps (f) and
Page EN-31
(f) (i)