hanseatic HGU4582D97710DI Gebrauchsanleitung Seite 80

Page EN-38 Troubleshooting table
Problem
A peep tone will sound every
minute.
The water is not running or it
is running only very slowly.
The water is not running off or
only very slowly.
The dishwasher is not
watertight.
The dishwasher can be
switched on/off, but not can-
not be operated.
Error code
:
E1
It takes too long for the water
to fill up.
:
E3
Required temperature is not
reached.
:
E4
Water overflow.
Possible cause
The water tap is turned off
when the programme is
started.
The dishwasher door is not
closed and the programme
has been launched.
Programme pauses.
There is a kink in the inlet
hose.
The water tap is not on
properly.
The filters are blocked.
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
The washer is still in the
exhaust manifold.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the dishwasher
door is closed.
Solution
Turn the water tap on completely.
Arrange the inlet hose properly so that it is not kinked
(see "Connecting the inlet hose" on page EN-29).
Ensure that the water pressure is correct. See "Technical spec-
ifications" on page EN-42.
Have the appliance examined and repaired.
Switch off the tap. Find the gap in the seal (or have someone find
it) and repair the leak (or have it repaired). If water has collected
in the collection tray at the bottom of the appliance, empty this
before restarting the appliance.
Solution
Turn the water tap on
completely.
Close the dishwasher door.
Press the button (6).
Lay out the inlet hose in such
a manner that it is not kinked.
Turn the water tap on
completely.
Clean the filters
(see page EN-26).
Lay out the outlet hose in the
proper manner
(see page EN-28).
Replace the washer with a
sealing ring.
Have the door seal replaced
(see page EN-40).
Have the defective hose
replaced (see page EN-40).
Close the dishwasher door.