Instruction manual
5.6
Manual operation
Step
1
If manual drive is required, first grip the drive block (pos. 1) and peel 3 turns.
2
Then grip handle (pos. 2) and continue peeling process.
3
Rotate evenly and hold axial position.
5.7
Additional notes
In case of an insufficient peeling result the blade has to be replaced.
•
In consideration of the installation instructions of the fitting manufacturer and the tolerances specified therein (max. gap bet-
•
ween pipe and fitting) the pipe may be peeled a second time.
The peeler blades are subject to wear.
•
Use only on cleaned pipe surfaces.
•
Keep the pipe end peeler RSE clean and dry in the box or case!
•
The thickness of the peeling must be checked with a circumferential measuring tape on a regular basis.
•
36
Pos. 1
3x 360°
Pos. 2
Action
x
x