Lowering The Peeler Arm And Connection Of The Cordless Drill / Handle - GF RSE Bedienungsanleitung

Instruction manual
5.4

Lowering the peeler arm and connection of the cordless drill / handle

Note
The below description of the peeling procedure is using a cordless drill as an example. Similarly the handle can
also be used to operate the peeler.
Use cordless drill whenever possible. Recommended max. speed = 200rpm.
Step
1 Lowering the peeler arm and connection of the cordless drill
Press on the short end of the peeler arm and turn the wheel, so that it does not hold the peeler arm in its upper position
anymore. Carefully lower the peeler blade so that it does not abruptly hit the pipe surface. If you want to use the cordless
drill, remove the handle and then connect the drill to the bit.
Note
The peeler blade must rest on the pipe end in such a way that during the first rotation no section of the pipe end
remains unpeeled. It is helpful to position the peeler blade in such a way that it rests with its dull section on the
pipe edge. This ensures that the whole pipe end will be peeled successfully.
Carefully lower the peeler blade so that it does not abruptly hit the pipe surface.
34
Action