Intended Use; About This Document; Warnings - GF RSE Bedienungsanleitung

Instruction manual
1

Intended use

The pipe end peelers RSE are meant exclusively for the removal of the oxide layer on polyethylene pipes as preparation for
electrofusion (EF). The peeler can be used for pipe end and spigot fittings and outlets. Additionally the pipe end peeler RSE is
approved for usage on polypropylene (PP) and cross-linked polyethylene (PE-X) pipes.
The peeling tools feature a bit which makes it possible to use them together with standard cordless screwdrivers.
Warning!
Intended use only
It is not allowed to use the tool for any application not covered by the above stated terms. Modifying the tool without consulting the
manufacturer is forbidden and shall be considered as improper use.
The manufacturer is not liable for the use of the pipe end peeler RSE outside of the intended use!
2

About this document

This document contains all the necessary information to assemble, commission or maintain the product.
2.1

Warnings

In this instruction manual, warnings are used, which shall warn you of death, injuries or material damage. Always read and observe
these warnings!
DANGER!
Imminent danger!
Non-observance may result in major injuries or death.
► Measures to avoid the danger.
WARNING!
Possible danger!
Non-observance may result in major injuries.
► Measures to avoid the danger.
CAUTION!
Dangerous situation!
Non-observance may result in minor injuries.
► Measures to avoid the danger.
NOTICE!
Dangerous situation!
Non-observance may result in material losses.
► Non-observance may result in damage to property (loss of time, loss of data, machine defect, etc.)!
24