techem vario 4.1.3 Betriebsanleitung Seite 27

L4
Date (entry 4)
L5 Date (entry 5)
1 Only with heat meters or heat/cold meters
2 Only with cold meters or heat/cold meters
* Before the first due date: Production date or optional starting date
KT = Short button press < 3s
LT = Long button press ≥ 3s and < 10s
2s = No button press, automatic switching of the display after 2s
Configuration level - to set the variable device properties
- C4 – C5 "Place" - Installation location (
To set e.g. the inlet place of installation, the following procedure is required:
Change to the ribbon "Metrological configuration" (C0 - Config)
1
Press the button briefly until the C5 display appears.
2
Then, press the button longer until the display changes to "Set" .
3
Inlet has been set. After changing the configuration of the installation location, the
4
sensor allocations to the clamping units T
!
The variant with a sensor integrated in the volume measuring section must be re-
placed with the freestanding temperature sensor in order to maintain the correct
sensor colour marking.
Please note:
If the button is not activated, the display jumps back to "C0 – Config" .
Restriction of parametrisation, see "Device properties" chapter.
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
) - outlet/
and T
VL RL
- inlet)
remain valid.
27