techem vario 4.1.3 Betriebsanleitung Seite 26

S1
Radio on/off (only for devices
with radio)
S2
Future due date
S3 Serial number
S4 Firmware version calibration
relevant part
S5
M-bus primary address
S6
Module code
S7
Pulse output 1, unit, valency
S8 Pulse output 2, unit, valency
S9 Pulse input 1, unit, valency
SM
Glycol mix
Module recognition
"----"
"mbus"
"pulsOut"
4
Metrological log
Sequence 1
L0
Log
L1
Date (entry 1)
L2
Date (entry 2)
L3 Date (entry 3)
26
Firmware version not a
calibration relevant part
No module
M-Bus module
2x pulse output modules
Sequence 2
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
Firmware Firmware
version – check sum
Techem part calibration
relevant part
Sequence 3