The Washing Results And Drying Results Are Not Satisfactory - Electrolux GA45GLV220 Benutzerinformation

Malfunction
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the malfunction occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
The necessary information for the service
centre is on the rating plate.

The washing results and drying results are not satisfactory

Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, whitish
stains, or a bluish layer on
glasses and dishes.
Dry water drop stains on
glasses and dishes.
All manuals and user guides at all-guides.com
Possible cause
The mains plug is not connec-
ted in the mains socket.
The fuse in the fuse box is
damaged.
The delay start is set.
Record this information:
– Model
– Product number
– Serial number
Possible cause
The washing programme was
not applicable for the type of
load and soil.
You did not put the items cor-
rectly in the baskets, water did
not touch all surfaces.
The spray arms could not turn
freely. Incorrect position of the
items in the baskets.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect level of the water soft-
ener adjustment.
The salt container cap is not
closed correctly.
The rinse aid quantity is too
high.
The rinse aid quantity is too
low.
The detergent can be the
cause.
Possible solution
Connect the mains plug.
Replace the fuse.
• Cancel the delay start.
• When the countdown is
completed, the washing pro-
gramme starts automatically.
(MOD.) ....................................................
....
(PNC) ..........................................
(S.N.) ..............................................
Possible solution
Make sure that the washing
programme is applicable for the
type of load and soil.
Put the items correctly in the
baskets.
Make sure that an incorrect po-
sition of the items do not cause
the blockage of the spray arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener with
the correct level.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid quantity.
Increase the rinse aid quantity.
Use a different brand of deter-
gent.
electrolux 63