Use Of The Appliance; Setting The Water Softener - Electrolux GA45GLV220 Benutzerinformation

• To adjust electronically the level of the
water softener.
• To activate or deactivate the rinse aid
dispenser (only with the multitab function
on).
• To deactivate or activate the acoustic
signals.
Activate the appliance. The appliance
is in setting mode when:
• The display shows two horizontal status
bars.
Activate the appliance. The appliance
is not in setting mode when:
• The display shows the time of the wash-
ing programme or of the delay start.
– It is necessary to cancel the pro-
gramme or the delay start to go back
to the setting mode. Refer to 'Select
and start a washing programme'.
Acoustic signals
You can hear the acoustic signals in these
conditions:
• The washing programme is completed.
• The level of the water softener is adjusted
electronically.
• The appliance has a malfunction.

USE OF THE APPLIANCE

1. Be sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener.
2. Fill the salt container with dishwasher
salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the appli-
ance.
5. Set the correct washing programme for
the type of load and soil.

SETTING THE WATER SOFTENER

The water softener removes minerals and
salts from the water supply. These minerals
and salts can cause damage to the appli-
ance.
All manuals and user guides at all-guides.com
Deactivating the acoustic signals
1. Activate the appliance.
2. Make sure that the appliance is in set-
3. Press and hold button (4) and button (5)
4. Release button (4) and button (5).
5. Press button (5),
6. Press button (5) to change the setting.
7. Deactivate the appliance to confirm.
To activate the acoustic signals again,
do steps (1) through (7).
6. Fill the detergent dispenser with the cor-
7. Start the washing programme.
Adjust the level of the water softener if this
does not agree with the water hardness in
your area.
Contact your local water authority to know
the water hardness in your area.
Factory setting: on.
ting mode.
at the same time until the indicators of
buttons (3), (4) and (5) flash.
• The indicators of buttons (3) and (4)
go off.
• The indicator of button (5) continues
to flash.
• The display shows the setting of the
acoustic signals.
The acoustic signals
are on.
The acoustic signals
are off.
rect quantity of detergent.
If you use the combi detergent tablets
('3 in 1', '4 in 1', '5 in 1'), use the multi-
tab function (refer to 'Multitab func-
tion').
electrolux 55