The Washing Results And Drying Results Are Not Satisfactory - Electrolux ESL 67070 Benutzerinformation

Malfunction Fault
code
After the check, switch on the appliance.
The programme continues from the point of
interruption.
If the malfunction shows again, contact the
service centre.
If the display shows other fault codes, con-
tact the service centre.
The necessary data for the service centre is
on the rating plate.

The washing results and drying results are not satisfactory

Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
All manuals and user guides at all-guides.com
Possible cause
The delay start is set.
We recommend that you write the data
here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener adjust-
ment
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the
cause.
You have set a washing pro-
gramme without drying phase
or with a decreased drying
phase.
electrolux 65
Possible solution
If you want to cancel the delay
start, refer to 'Select and start a
washing programme'.
....................
....................
....................
Possible solution
Make sure that the washing
programme is applicable for the
type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
Use a different brand of deter-
gent.
Let the door stay ajar for some
minutes before you remove the
dishes.