The Washing Results And Drying Results Are Not Satisfactory; Technical Data - Electrolux ESF 43020 Benutzerinformation

32 electrolux

The washing results and drying results are not satisfactory

Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and dull.

TECHNICAL DATA

Dimensions
Water supply pressure
1)
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener adjust-
ment
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the
cause.
You have set a washing pro-
gramme without drying phase
or with a decreased drying
phase.
The rinse aid dispenser is emp-
ty.
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Place settings
Possible solution
Make sure that the washing
programme is applicable for the
type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
Use a different brand of deter-
gent.
Let the door stay ajar for some
minutes before you remove the
dishes.
Fill the rinse aid dispenser with
rinse aid.
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
maximum 60 °C
446 mm
850 mm
620 mm
9