Use Of The Appliance - Electrolux ESL 66010 Benutzerinformation

24 electrolux
• Remaining time to the end of the pro-
gramme.
• End of a washing programme. The display
shows a zero.
• Number of hours in delay start.
• Fault codes.
• Activation/deactivation of the audible sig-
nals.
Programme selection buttons
With these buttons you can select the wash-
ing programme. Press a programme button,
the related indicator light comes on. Refer to
'Washing programmes' chapter for more da-
ta about the washing programmes.
Delay start button
Use the delay start button to delay the start
of the washing programme with an interval
between 1 and 19 hours. Refer to the chapter
'Setting and starting a washing programme'.
Function buttons
Use the function buttons for these opera-
tions:
• To set the water softener. Refer to the
chapter 'Setting the water softener'.
• To deactivate/activate the audible signals.
Refer to the section 'Audible signals'.
• To deactivate/activate the rinse aid dis-
penser, when multitab function is active.
Refer to the chapter 'Multitab function'.
Setting mode
The appliance is in setting mode when all the
programme indicator lights are on.
The appliance must be in setting mode for
these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
– To deactivate/activate the rinse aid dis-
penser.
The appliance is not in setting mode when
only one programme indicator light is on.

Use of the appliance

Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
Cancel the programme to go back to the
setting mode. Refer to the chapter 'Setting
and starting a washing programme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water
softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at
the factory.
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Release function buttons A and B.
5. Press the function button C.
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C
flashes.
– The digital display shows the setting.
The audible signals are activated.
6. Press the function button C again.
– The digital display shows the new set-
ting.
The audible signals are deactivated.
7. Switch off the appliance to save the op-
eration.
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the digital
display shows necessary setting.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.
5. Set the correct washing programme for
the type of load and soil.
Audible signals deactiva-
ted
Audible signals activated