Use Of The Appliance - Electrolux ESL2460 Benutzerinformation

Digital display
The display shows:
• Adjusted level of the water softener.
• Programme duration.
• Remaining time to the end of the pro-
gramme.
• End of a washing programme.
• Number of hours in delay start.
• Fault codes.
• Activation/deactivation of the audible sig-
nals.
Save energy button
This function decreases the temperature in
the drying phase. Saved energy is between
10% and 25%.
If dishes at the end of the programme
are wet, keep the door ajar to let the
dishes dry naturally.
This function is available with all washing pro-
grammes. The related indicator light comes
on when you press the button.
The save energy function has no effect on
some programmes. Refer to the chapter
'Washing programmes' for the list of pro-
grammes where save energy has or not an
effect.
Function buttons
Use the function buttons for these opera-
tions:
• To set the water softener. Refer to the
chapter 'Setting the water softener'.
• To deactivate/activate the audible signals.
Refer to the section 'Audible signals'.
• To cancel the washing programme in pro-
gress or a delay start in progress. Refer to
the chapter 'Setting and starting a washing
programme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water
softener.
• When the appliance has a malfunction.

Use of the appliance

Refer to the following instructions for each
step of procedure:
The activation of the audible signals is set at
the factory.
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Press the function button C.
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C
flashes.
– The digital display shows the setting.
The audible signals are activated.
5. Press the function button C again.
– The digital display shows the new set-
ting.
The audible signals are deactivated.
6. Switch off the appliance to save the op-
eration.
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the digital
display shows necessary setting.
Setting mode
The appliance is in setting mode when all the
programme indicator lights are on.
The appliance must be in setting mode for
these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
If a programme indicator light is on, cancel
the programme to go back to the setting
mode. Refer to the chapter "Setting and
starting a washing programme".
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
electrolux 5
Audible sig-
nals deactiva-
ted
Audible sig-
nals activated