Switching On And Off; Working With The Lawnmower - Parkside PRMA 20-Li A1 Originalbetriebsanleitung

Switching On and Off

1. Place the mower on a level sur-
face.
2. Lift the transparent cover (10) on
the device housing.
3. Slide the charged battery (11)
along the guide rail into the device.
You will hear it click into place.
4. Insert the ignition key (12) in to
the opening provided.
5. Before switching on, ensure that
the equipment is not in contact
with any objects.
6. To switch on, press the release
button (15) on the handle at the
same time as pressing the start
lever (16).
7. Release the release button (15).
8. To switch off, release the start
lever (16).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.
Working with the
Lawnmower
Regular mowing encourages increased foli-
ation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The fi rst cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Run the equipment at a walking pace,
in tracks that are as even as possible.
For gap-free mowing, the tracks should
always overlap by a few centimetres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
• Clean the equipment after each use, as
described in the chapter on "Cleaning,
Maintenance and Storage".
Switch off the equipment
after work and in order to
transport it, disconnect the
plug and wait until the blade
stops. There is a risk of in-
jury.
GB
13