Working With The Equipment - Parkside PHD 110 D1 Originalbetriebsanleitung

persons.
• Use the equipment only on a
flat, stable surface.
• The transport handle is exclu-
sively for transporting the equip-
ment. The equipment is portable
but not to be carried during
operation.
• For your safety, it is recommend-
ed that you wear safety glasses,
safety boots and gloves and, if
necessary, ear protection.
• In the event of a fault or defect
during operation, immediately
switch off and
ment. Then read page 15 of the
operating instructions for pos-
sible fault causes or
service centre.

Working with the equipment

Caution: to avoid accidents
and injuries:
CAUTION. pressure
washers can be dan-
gerous if they are not
operated correctly! The jet must
never be directed at people, ani-
mals, electric equipment connected
to the power supply or against the
actual pressure washer.
• Do not direct the jet at your-
self or others in order to clean
clothes and shoes.
• Do not operate the pressure
washer when other people are
in the immediate vicinity, other
than they are also wearing pro-
tective clothes.
• Always use the spray gun with
both hands. This will enable
unplug the equip-
contact our
GB
you to safely counter the recoil
force from the emerging water
jet.
• Take appropriate measures to
keep children away from the
equipment whilst it is running.
• Dispose of the packaging mate-
rial correctly.
• Do not use the equipment in the
vicinity of flammable liquids or
gases. Non-observance will re-
sult in a risk of fire or explosion.
• Do not spray combustible liq-
uids. Risk of explosion.
• Store the equipment in a dry
place and out of reach of chil-
dren.
• Children must be supervised in
order to ensure that they do not
play with the equipment.
• Ensure that no exhaust emis-
sions occur within the vicinity of
air inlets.
Caution! To avoid damage to
the equipment and any pos-
sible person injury resulting
from this:
• Do not work with damaged or
incomplete equipment, or with
equipment that has been con-
verted without the approval of
the manufacturer. Before initial
operation, have a specialist
check that the required electrical
protection measures are in place.
• Never operate the pressure
washer if the power supply
cable or other important parts,
such as the high-pressure hose
or the gun, are damaged.
• Protect the pressure washer
from frost and dry running.
IE NI CY
7