Working With The Equipment - Parkside PHD 110 D1 Originalbetriebsanleitung

GB IE
persons.
• Use the equipment only on a
flat, stable surface.
• The transport handle is exclu-
sively for transporting the equip-
ment. The equipment is portable
but not to be carried during
operation.
• For your safety, it is recommend-
ed that you wear safety glasses,
safety boots and gloves and, if
necessary, ear protection.
• In the event of a fault or defect
during operation, immediately
switch off and
ment. Then read page 28 of the
operating instructions
sible fault causes or contact our
service centre.

Working with the equipment

Caution: to avoid accidents
and injuries:
CAUTION. pressure
washers can be dan-
gerous if they are not
operated correctly! The jet must
never be directed at people, ani-
mals, electric equipment connected
to the power supply or against the
actual pressure washer.
• Do not direct the jet at your-
self or others in order to clean
clothes and shoes.
• Do not operate the pressure
washer when other people are
in the immediate vicinity, other
than they are also wearing pro-
tective clothes.
• Always use the spray gun with
both hands. This will enable
20
unplug the equip-
for pos-
you to safely counter the recoil
force from the emerging water
jet.
• Take appropriate measures to
keep children away from the
equipment whilst it is running.
• Dispose of the packaging mate-
rial correctly.
• Do not use the equipment in the
vicinity of flammable liquids or
gases. Non-observance will re-
sult in a risk of fire or explosion.
• Do not spray combustible liq-
uids. Risk of explosion.
• Store the equipment in a dry
place and out of reach of chil-
dren.
• Children must be supervised in
order to ensure that they do not
play with the equipment.
• Ensure that no exhaust emis-
sions occur within the vicinity of
air inlets.
Caution! To avoid damage to
the equipment and any pos-
sible person injury resulting
from this:
• Do not work with damaged or
incomplete equipment, or with
equipment that has been con-
verted without the approval of
the manufacturer. Before initial
operation, have a specialist
check that the required electrical
protection measures are in place.
• Never operate the pressure
washer if the power supply
cable or other important parts,
such as the high-pressure hose
or the gun, are damaged.
• Protect the pressure washer
from frost and dry running.