Herunterladen Diese Seite drucken

LaserLiner MultiFinder Pro Bedienungsanleitung Seite 14

Vorschau ausblenden Andere Handbücher für MultiFinder Pro:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Move the tool
Slide the tool sideways across the wall. When the
maximum display appears, mark the position.
Wires which are at a depth of more than 4 cm may
!
not be detected. Always switch off the power supply
when working near electric wires.
Tip 1: Because of static charges, electric fields may be detected
at the side of the actual position of the wire. To carry away
these charges, lay your free hand on the wall.
Tip 2: Move the tool slowly as friction can generate interfering
electric charges.
Tip 3: If you suspect that wires must be present but cannot
find any, this may be because they are shielded in conduits.
Use METAL-SCAN in order to localise conduits.
Tip 4: Metal in walls (e.g. metal studs) transmit electrical fields
and may therefore cause interference. In this case, switch to
METAL-SCAN in order to find the wire.
Tip 5: The position where you start is important: To achieve
maximum sensitivity, start by placing the device in a position
which is known not to be near live wires.
7
METAL-SCAN / AC-SCAN Current monitoring
14
GB
Then scan from the
other side.
Continuous current
monitoring in unshielded
wires as soon as an
electrical field is detected.

Werbung

loading