LaserLiner MultiFinder Pro Bedienungsanleitung Seite 13

Tip 6: Ensure that you have really detected a stud. To do so,
check on both sides whether other studs are present at equal
distances, usually at 30, 40 or 60 cm. Also check that it is a
stud by scanning at several places directly above and below
the position of the first find.
Tip 7: Textured ceilings: The ceiling must be covered with
cardboard to protect it. In this case, use the DeepScan
function.
If electric wires or metal or plastic pipes are located
near or in contact with a plaster fibreboard panel,
!
they may be identified by the MultiFinder as studs.
Always switch off the power supply when working
near electric wires.
Special things to note with various materials
It may not be possible to detect wooden studs or joists
through the following materials:
– Ceramic floor tiles
– Fitted carpeting with padded backing
– Wallpaper with metal fibres or metal foil
– Freshly painted, damp walls. These must have dried for
at least one week.
– In problem cases, use METAL-SCAN to localise nails or screws
in dry walls that line up vertically where a stud is located.
6 AC-SCAN
For localising live wires directly beneath the plaster or behind
wooden panels and other non- metallic panelling. It is not
possible to detect live wires in dry walls with metal studs.
– Select AC-SCAN (button 6). The device is calibrated
automatically.
– Place the tool against the wall.
– MOVE: Move the tool slowly across the surface.
MultiFinder Pro
13
GB