Service And Maintenance - Protool PDC 12-4 TEC Li Originalbetriebsanleitung

8.4 Tool holder in the drill spindle
[9]
Bits can be inserted directly into the hexa-
gon socket holder of the drill spindle.
8.5 Depth stop [10]
The depth stop (partly as an accessory) al-
lows the user to insert screws to a pre-
defined depth. You can set the dimension
by which the screw head protrudes above
or is recessed below the surface of the
workpiece.
Depth setting
Turn the housing [10-1] to
set the desired fastening
depth. Each detent position
changes
depth by 0.1 mm.
Sleeve A/B must be removed before a
screw can be unscrewed.
9 Working with the machine
9.1 On/Off switch [1-4]
Press = ON, release = OFF
The speed of the machine depends on
how far the on/off switch is pressed in.
9.2 Bit depot [1-3]
Magnetic, for storing bits and bit holders.
9.3 Belt clip [1-10]
The user can attach the machine to work
clothing for short periods using the belt
clip (right/left).
9.4 Attaching the additional han-
dle[5]
Always use the additional handle.
Position the additional handle [5-2] on
the extension of the gearbox housing
and engage the recesses on the addi-
tional handle in the lugs on the housing.
Turn the handle until secured in posi-
tion.
Turn the handle to adjust the position in
30° increments.
The drilling depth can be adjusted using
the depth stop [5-1].
9.5 Acoustic warning signals
Acoustic warning signals sound and the
machine switches off in the following oper-
ating states:
All manuals and user guides at all-guides.com
peep
the fastening
Note the following information:
– Keep the ventilation slits on the machine
– Keep the contacts on the machine, char-
Information on battery packs
– Store in a cool, dry place at a tempera-
– Protect battery packs from moisture,
– Do not leave flat battery packs in a char-
– If you intend to store li-ion battery packs
– To avoid short circuits the battery pack
– Significantly shorter operating times af-
10.1
– Preset torque reached.
– "Block protect" - starting torque too
high.
– Machine overloaded
10

Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the battery pack from
the machine before any maintenance or
care work!
All maintenance and repair work which
requires the motor housing to be
opened, must only be carried out by an
authorised service workshop.
free and clean to ensure adequate cool-
ing.
ger and battery pack clean.
ture between 5 °C and 25 °C.
water and heat.
ger disconnected from the mains power
supply for longer than one month. Dan-
ger of deep discharge!
for longer periods without use, you
should charge them to 40 % capacity
(approx. 15 min charging time).
should be stored in the packaging sup-
plied.
ter each charge indicate that the battery
pack is worn and should be replaced with
a new one.
After-sales service and repair
Always contact the manufactur-
er or an authorised service
workshop. Find the address of
your nearest workshop at:
www.protool-online.com/ser-
vice
15