Switching On And Off; Attaching The Guide Fence; Attaching The Mitre Guide; Sawing - Parkside PTKS 1800 SE Bedienungs- Und Sicherheitshinweise

CAUTION: Be sure to fix / secure the
saw blade
4
of angle setting.

Switching on and off

Q
The table saw has a soft start system.
To switch on:
j
Press the green switch I of the ON / OFF
switch .
16
Switching off the device:
j
Press the green switch 0 of the ON / OFF
switch .
16
Emergency switch off:
j
Press the cover of the ON / OFF switch
closed.
Unlocking the ON / OFF switch cover:
j
Slide the emergency knob upwards and flip
the ON / OFF cover upwards.

Attaching the guide fence

Q
Attach the guide fence
on to both sides of the saw table
and pressing the handle downwards.
"HIgH" setting (see Fig. N):
j
Attach the guide fence attachment
broader side to the guide fence
Set the desired cutting width on the centimetre
scale "High".
"LOW" setting (see Fig. N):
j
Attach the guide fence attachment
narrower side to the guide fence
Set the desired cutting width on the centimetre
scale "Low".
again after each change
This produces a short
delay when the ma-
chine starts.
16
by hooking it
1
5
with its
1a
.
1
with the
1a
.
1

Attaching the mitre guide

Q
Note: Use the mitre guide
stalled (with the guide rails). Slide the mitre guide
from the front into the groove
8
table . The angle can be set to ± 60° by loosen-
5
ing the mitre guide handle
Angle stop:
With the three stops
8a
± 90° / ± 45° using the angle stop

Sawing

Q
Straight cut:
j
First set the required blade height.
j
You can set the inclination angle if required.
j
Attach the guide fence
j
Sawing a long workpiece (≥ 2.5 m) needs
careful planning in advance. Work on long
workpieces should be carried out together with
a second person who is experienced and
knows how to use the saw. This person is there
to hold and support the workpiece. Ensure that
the second person is also wearing all the rec-
ommended protective clothing.
j
Switch on the machine as described above.
j
Push the workpiece evenly in the direction of
the saw blade (see Fig. F). Saw the work-
4
piece in one complete sawing operation.
Use the push stick
12
the guide fence
1
≤ 120mm.
j
Switch off the machine immediately if you are
not going to continue to use it.
Mitred cuts:
j
Set the required blade height.
j
You can set the angle if required.
j
Attach the mitre guide.
j
First slide the mitre guide
j
Loosen the handle of the mitre guide using the
clamping screw
8c
retighten the handle of the mitre guide using
the clamping screw
j
Press the workpiece against the mitre guide
j
Switch on the machine as described above.
Operation
only when fully in-
8
in the saw
6
.
8c
you can set at angles of
(see Fig. L).
8d
.
1
if the distance between
and the saw blade
4
into the groove
8
, set the desired angle and
.
8c
GB
is
.
6
.
8
13