Before use
Check that the blade guard is
functioning correctly
WARNING! RISK OF INJURY!
■
Switch off the appliance and pull out the
power plug before starting any work on
the appliance .
■
Make sure that all moving parts of the blade
guard
move freely without jamming and all
devices designed to cover the saw blade are
working correctly .
■
Activate the blade guard
release lever for the blade guard
♦
Pull the release lever for the blade guard
all the way back .
When you let go of the release lever for the
blade guard
, the blade guard
move freely back to its starting position .
Initial operation
The PHKS 1350 C2 circular saw has Intelligent
Power Control . This automatic power delivery
system ensures that for a particular speed range
the power output remains constant when working
on harder and more resistant materials .
Fitting/changing the saw blade
NOTE
►
All blades used should conform to EN 847-1 .
■
Use only saw blade with diameters corre-
sponding to the label on the saw .
Always pull out the plug from the mains before
changing the saw blade
1 . Set the cutting depth (using the locking screw
to the minimum position, 0 mm .
2 . Swing the blade guard
lever
and put the device down .
3 . Press the spindle lock button
and use the Allen key
screw/washer
. Now remover the clamping
screw/washer
and the clamping flange
(see also Fig . A) .
■
36
│
GB │ MT
only using the
.
must
!
back using the release
(until it engages)
to release the clamping
Fig. A: Changing the saw blade
4 . Remove saw blade
5 . Fitting a saw blade
reverse order .
6 . Press the spindle lock button
and use the Allen key
screw/washer
WARNING!
►
The arrow on the saw blade
spond to the arrow showing the direction of
rotation (running direction shown on the
device) .
■
Ensure that the saw blade
rotational speed of the tool .
Mounting/setting the guide fence
♦
Loosen the wing screw
fence
into the guide fence slot
♦
Set the desired cut width with the help of the
scale on the guide fence
arrow in the base plate
)
♦
Fig. B: Cutting width 3 cm
♦
Retighten the wing screw
.
is carried out in the
(until it engages)
to tighten the clamping
.
must corre-
is suitable for the
and insert the guide
.
and the marking
(see also Fig . B) .
.
PHKS 1350 C2