Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Operation; Fitting/Changing The Saw Blade; Mounting/Setting The Guide Fence; Connecting The Sawdust Extraction Appliance - Parkside PHKS 1350 B2 Originalbetriebsanleitung

Handkreissäge
Vorschau ausblenden Andere Handbücher für PHKS 1350 B2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 72

Initial operation

The PHKS 1350 B2 circular saw has Intelligent
Power Control. This automatic power delivery
system ensures that for a particular speed range
the power output remains constant when working
on harder and more resistant materials.

Fitting/changing the saw blade

NOTE
All blades used should conform to EN 847-1.
Always pull out the plug from the mains before
changing the saw blade
1. Set the cutting depth (using the locking screw
to the minimum position, 0 mm.
2. Swing the blade guard
lever
and put the device down.
3. Press the spindle lock button
and use the Allen key
screw/washer
. Now remover the clamping
screw/washer
and the clamping flange
(see also Fig. A).
Fig. A: Changing the saw blade
4. Remove saw blade
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
and use the Allen key
screw/washer
.
WARNING!
The arrow on the saw blade
spond to the arrow showing the direction of
rotation (running direction shown on the
device).
GB │ IE │ CY
8 
!
back using the release
(until it engages)
to release the clamping
.
is carried out in the
(until it engages)
to tighten the clamping
must corre-
Ensure that the saw blade
rotational speed of the tool.

Mounting/setting the guide fence

Loosen the wing screw
fence
into the guide fence slot
Set the desired cut width with the help of the
scale on the guide fence
arrow in the base plate
)
Fig. B: Cutting width 3 cm
Retighten the wing screw
Connecting the sawdust extraction
appliance
Attach the adapter for dust extraction
chip ejector
Connect an approved dust and chip extraction
device.

Operation

Switching on and off
Switching on:
Push the safety lock-out
and keep it pressed.
Press the ON/OFF switch
running you can release the safety lock-out
Switching off:
Release the ON/OFF switch

Setting the cutting angle

You can select the cutting angle with the help of the
cutting angle scale
Release the wing screw on the cutting angle
preselector
, set the desired angle on the
cutting angle scale
wing screw.
is suitable for the
and insert the guide
.
and the marking
(see also Fig. B).
45
0
.
.
to the left or right
. Once the saw is
.
.
and then re-tighten the
PHKS 1350 B2
to the
.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis