Cleaning Of The External Chassis; Decalcification - Isomac GIADA Bedienungsanleitung Und Wartungsanleitung

English
If the machine is not frequently used, turn off the ON/OFF switch and unplug the power cord by
pulling on the plug.
Attention: do not switch on the pump without water.
8 – CLEANING OF THE EXTERNAL CHASSIS
Clean the outside of the machine with a soft damp cloth and then dry it.
Never use alcohol, solvents, abrasives or detergents as they may harm the surfaces.
Never immerse the machine in water, even partially.
9 – DECALCIFICATION
The machine will need to be decalcified periodically depending on how often it is used and the
hardness of the water.
Use only products that are specific to this purpose that can be found also at the authorized SERVICE
CENTRES.
Dissolve the decalcifying agent completely in a container of water (1,5 L), then pour the solution into
the water tank (1).
Place a suitable container under the coffee group (5) and under the turbo steam nozzle (6).
Turn on the coffee/hot water switch (14) and let the solution flow through the coffee group (5) for 15
seconds. Then turn off the coffee/hot water switch. Turn on the steam switch (15) and the coffee/hot
water switch (14) and slowly open the steam knob (anticlockwise) (4) and let water flow through the
steam nozzle (6) for several seconds. Then turn off the steam switch and the coffee/hot water switch.
Wait 20 minutes and repeat the above steps until the solution in the water tank has
reached the minimum water level.
Remove the water tank (1), rinse it thoroughly, refill it with clean water and put it back into the
machine.
25