Positioning The Appliance; Connecting The Flue Pipe; Transport Lock (Models With Sliding Door) - Austroflamm 65x Montagehandbuch

EN
1.6

Positioning the appliance

Place the appliance on a prepared, stable surface and
align the four adjustable feet using an SW24 hexagonal
wrench. If the length of the threaded rod is insufficient, the
four supports can be adjusted in height.
or
Place the unit on a prepared, stable surface and align the
four adjustable feet using an SW24 hexagonal wrench.
The feet can be used to compensate a difference in height
of up to 10 cm.
1.7

Connecting the flue pipe

Aligning the flue outlet:
- By rotating the flue gas collector by up to 360°, it can be locked in any position.
Then firmly tighten the fastening screws.
- By rotating the flue outlet by up to 360°, any angle of inclination can be obtained when
the flue dome is also rotated.
- All the required seals are affixed to the cast components.
1.8
Transport lock
Before cladding the fireplace insert, please remove the transport lock and check the function of the sliding door.
Depending on the model, the counterweight of the sliding door is secured with a coloured screw and a washer on
the left outer side or on both outer sides, or on the rear wall of the appliance.
Flat and corner fireplace inserts
The sliding door counterweight is secured with a screw on
each side of the appliance.
CAUTION:
These transport safety screws must be removed before
installing the appliance!
(models with sliding door)
5
FIREPLACE INSERTS / SLIDING DOOR
1
www.austroflamm.com 5
english