Carrying Aid; Setting Up The Fireplace Insert - Austroflamm 65x Montagehandbuch

FIREPLACE INSERTS / SLIDING DOOR
1.4

Carrying aid

The Austroflamm fireplace inserts (with the exception of 71x51/57 S3, 69x49x57 and 89x49x57) are equipped with a
carrying aid, intended to make it easier for you to transport the fireplace insert to the installation site.
80x64S / 80x64SII / 97x45S / 97x74S / 120x45S
Loosen the screws and remove the
carrying aids.
80x64SII with ready mounted carrying
aids.
The appliance is now ready to be transported.
After transportation, the carrying aids must be removed from the appliance.
CAUTION:
The screws (see figure 1) must be screwed back into the body (even if the carrying aids are not screwed
back onto the appliance -> otherwise the appliance will not be airtight).
1.5

Setting up the fireplace insert

CAUTION:
Please be sure to observe the fire protection specifications, such as thermal insulation and air grid sizes. If the fireplace
insert is fed an excessively high quantity of fuel, there is a risk of the chimney and adjacent components or furniture
overheating. Fire hazard!
4 www.austroflamm.com
Undo the fastening screws and align
the carrying aids.
CAUTION: Pay attention to the spacers! The
carrying aid must be screwed on evenly!
Conversion of the carrying aids, suita-
ble for 80x64S, 97x..S and 120x45S.
CAUTION: Pay attention to the spacers! The
carrying aid must be screwed on evenly!
4
Fasten the carrying aids evenly on
the sides by means of the removed
fastening screws.
80x64S with ready mounted carry-
ing aids.
english
EN