Safety Instructions - Sika E2 Betriebsanleitung

Safety instructions

1 Safety instructions
Read through the operating manual carefully. Follow all instructions and notices to prevent
injury or damage to property.
Intended use
The digital pressure gauge may only be used for checking, adjusting and calibrating pressure
measuring devices.
The digital pressure gauge must not be used outside the specification or in violation of the
operating instructions.
WARNING
The digital pressure gauge is not a safety component in accordance with Di-
rective 2006/42/EC (Machine Directive).
 Never use the device as a safety component.
The operational safety of the device supplied is only guaranteed by intended use. The speci-
fied limits ( p. 32) may under no circumstances be exceeded.
This applies in particular to compliance with the permissible pressure range end value and
the permissible temperature range.
WARNING
Exceeding the maximum overload values can lead to material failure of the digital
pressure gauge. This can cause serious damage to health.
 Make sure that the overload values are never exceeded.
Qualified personnel
• The personnel in charge of the installation, operation and maintenance of the device
must hold a relevant qualification. This can be based on training or relevant instructions.
General safety instructions
Degree of protection according to EN 60529:
•
Ensure that the ambient conditions at the place of use do not exceed the requirements of
the specified degree of protection ( p. 32).
• Only use the device in perfect condition. Damaged or faulty devices must be checked im-
mediately and replaced if necessary.
Do not remove or destroy type plates or other markings on the device, or the warranty is
•
rendered null and void.
- 22 - © SIKA • Ba_Ref-E2D2C2 • 07/2021
E2 / D2 / C2