Internal Cleaning; Instructions For Scl K07-Td / K08-Td; Instructions For Scl K09-Td / K10-Td / K11-Td - FPZ SCL K07 TD-MOR Betriebsanleitung

6.1

INTERNAL CLEANING

Should it be necessary to clean the inside of the unit,
proceed as follows:
6.1.1 INSTRUCTIONS FOR K07-TD / K08-TD
1. Position the unit in a vertical position with the fan guard
cowling on a flat, stable surface.
2. Remove in order (915) and (902) screws placed on (162)
cover.
3. Remove (162) cover by using the two threated place on
cover itself.
4. Remove the (900) screw and (365) washer.
5. Remove the (360) bearing cover and extract the (321)
bearing using a bearing puller.
6. Remove the (231) impeller if necessary using a puller and
(940) key.
7. Remove the (902) screws placed on (104) intermediate
cover.
8. Remove components (103) and (104) and place them
together, by using the two threaded holes placed on (104)
intermediate cover.
9. Remove the (934) spacer.
10. Remove the (935) shims-be careful not to misplace.
11. Remove the (230) impeller through the extractor if
necessary and (940) key.
Clean and reassemble following the instructions in reverse
order, and forming the (423) seal using Loctite 5970 or a similar
product after having carefully cleaned the surfaces previously
sealed.
It's important not to reverse the position of the (230) and
(231) impellers.
940 900 365
Extraction's
threaded holes
423
Extraction's
threaded holes
321 915 360 934
162
902
231
103
104
935
230
940
Flat, stable support surface
6.1.2 INSTRUCTIONS FOR K09-TD / K10-TD / K11-TD
1. Position the unit in a vertical position with the fan guard
cowling on a flat, stable surface.
2. Remove in order (915) and (902) screws placed on (162)
cover.
3. Remove (162) cover by using the two threated place on
cover itself.
4. Remove the (900) screw and (365) washer.
5. Remove the (360) bearing cover and extract the (321)
bearing using a bearing puller.
6. Remove the (951) spacer ring.
7. Remove the (231) impeller if necessary using a puller and
(940) key.
8. Remove the (902) screws placed on (104) intermediate
cover.
9. Remove components (103) and (104) and place them
together, by using the two threaded holes placed on (104)
intermediate cover.
10. Remove the (934) spacer.
11. Remove the (935) shims-be careful not to misplace.
12. Remove the (230) impeller through the extractor if
necessary and (940) key.
Clean and reassemble following the instructions in reverse
order, and forming the (423) seal using Loctite 5970 or a similar
product after having carefully cleaned the surfaces previously
sealed.
It's important not to reverse the position of the (230) and
(231) impellers.
940
Extraction's
threaded holes
423
Extraction's
threaded holes
GB - 27/69
915 934
951 900 365 321 360
Flat, stable support
surface
162
902
231
103
104
935
230
940