4.1.3.1 Installation With 90° Manifold; Installation Without 90° Manifold; Horizontal Installation; 4.1.5 Vertical Installation On The Cover - FPZ SCL K07 TD-MOR Betriebsanleitung

fig. 1
fig 2
fig 3
4.1.3.1 INSTALLATION WITH 90° MANIFOLD
For final assembly and to put in operation, proceed as
follows:
1. Remove the protective plug in intake manifold port.
2. Place (424) gasket on intake port.
3. Select the desired
fig. 3).
4. Place the #706 manifold with the (700) silencer housing on
(424) gasket and seal all the way around with (904) screws
using the key (ch13) as provided.
700
906
424
706
424
904
4.1.3.2 START-UP WITHOUT 90° MANIFILD
Using the blower without the 90° manifol d (ref. fig. 4)
1. Disassemble the (706) manifold from the intake housing,
removing the (906) screw.
2. Place the (424) gasket on the intake port of the blower.
3. Place the (700) silencer housing on (424) gasket and seal
all the way around with (906) screws using the key (ch13)
as provided.
fig 4
orientation (see fig. 1, fig. 2,
4.1.4

HORIZONTAL INSTALLATION

The unit is ready for installation in a horizontal position, suitably
fixed to the bracket/ brackets.
The bracket has fixing holes. Use all the holes and suitable bolt
types.
See point 4.1.2 for the INSTALLATION CONDITIONS.
Remove the covers over the openings before checking the
direction of rotation and before final connection.
WARNING!
Check the direction of rotation in the motor.
(See point 4.2.3 ROTATION DIRECTION)
When connecting the unit cabin to the ducting, do so using the
flanges on the silencer housings and form suitable connections
using flexible hoses. Avoid rigid connections that may impose
loads and give rise to harmful vibrations.
Fit the flanges on the silencer housings complete with gaskets
again, and tighten.

4.1.5 VERTICAL INSTALLATION ON THE COVER

For installing in a vertical position, fit the anti-vibration supports
supplied with the unit on the cover, and then fix the whole
structure to the support.
See point 4.1.2 for the INSTALLATION CONDITIONS.
Any use other than the intended use of the
unit may cause serious injury and even
death!
When installing vertically DO NOT use the bracket supplied
with the unit as this is only suitable for horizontal
installations.
Remove the covers over the openings before checking the
direction of rotation and before final connection.
WARNING!
Check the direction of rotation in the motor.
(See point 4.2.3 ROTATION DIRECTION)
When connecting the unit to the ducting, do so using the
flanges on the silencer housings and form suitable connections
using flexible hoses. Avoid rigid connections that may impose
loads and give rise to harmful vibrations.
Fit the flanges on the silencer housings complete with gaskets
again, and tighten.
GB - 23/69