Print Menu - OHAUS Defender 6000 Bedienungsanleitung

Defender 6000 Indicators
[ ]
PArItY
Parity
Set the data bits and parity.
7 EVEN
= 7 data bits, even parity
7 ODD
= 7 data bits, odd parity
7 NONE
= 7 data bits, no parity
8 NONE
= 8 data bits, no parity
[ ]
StOP
Stop bit
Set the number of stop bits.
1
= 1 stop bits
2 = 2 stop bits
[H.SHAKE
Handshake
Set the flow control method. Hardware handshaking is only available for COM1 menu.
NONE
= no handshaking
ONOFF
= XON/XOFF software handshaking
Alternate Print command
Set the alternate command character for Print.
Settings of A (a) to Z (z) are available. The default setting is P.
Alternate Tare command
Set the alternate command character for Tare.
Settings of A(a) to Z(z) are available. The default setting is T.
Alternate Zero command
Set the alternate command character for Zero.
Settings of A (a) to Z (z) are available. The default setting is Z.
[End]
End
Advance to the next menu or return to the top of the current menu.

4.7.2 Print Menu

Enter this menu to set printing parameters. Default settings are bold.
Menu Sub-Menu
Assignment
Print
( P.r.I.N.t.I) /
2nd Print
( P.r.I.N.t.2)
Template
Reset
End
]
[ ]
Alt.P
[ ]
Alt.t
[ ]
Alt.z
Sub-
Menu (in
segment)
Stable Weight Only
[Demand]
Mode
[Auto On Stable]
Time
[Interval (seconds)]
Checksum
[MT-Continuous]
Options
Demand, Auto On Stable,
ASSIGN
Auto On Accept,
Interval(seconds), MT-
Continuous, OH-
Continuous, SICS
Stable
Off, On(LFT Force On)
mMODE
Load, Load and Zero
tImME
1~50000
C.SUmM
On, Off
tEmMp
Simple, Custom 1, Custom
2, Custom 3, Custom 4,
Custom 5
reset \
End \
EN-37
Options (in
segment)
DemMaN, ON.Stab,
ON.ACep, INter,
mMt.CON, OH.CON,
SICS
OFF, ON
LOAD, LOAD,;2r
/
ON, OFF
SImMp, CUst1,
CUst2, CUst3,
CUst4, CUst5
/
/