Installation; Unpacking; External Connections; Scale Base With Easyconnect Tm Connector - OHAUS Defender 6000 Bedienungsanleitung

Defender 6000 Indicators

2. INSTALLATION

2.1

Unpacking

Unpack the following items:
 i-DT61PW or i-DT61XWE indicator
6 cells of D size dry batteries (i-DT61PW only)

Mounting bracket

Knobs (2)

Quick installation guide

 Instruction manual
2.2

External Connections

2.2.1 Scale Base with EasyConnect
To connect the OHAUS scale base with EasyConnect
onto the external load cell connector located at the bottom of the terminal. Then rotate the base connector's
locking ring clockwise. Check the following illustration for details.

2.2.2 Power input to i-DT61PW

Use 6 cells of D size dry batteries. During battery operation, the battery symbol indicates the battery status.
Battery 5%~25% remaining
Battery 25%~50% remaining
Battery 50%~75% remaining
Battery 75%~100% remaining

2.2.3 AC Power to i-DT61XWE

Connect the AC plug to an electrical outlet.
2.3

Internal Connections

Some connections require the housing to be opened.

2.3.1 Opening the Housing

CAUTION: ELECTRICAL SHOCK HAZARD. REMOVE ALL POWER CONNECTIONS TO THE
INDICATOR BEFORE SERVICING OR MAKING INTERNAL CONNECTIONS. THE HOUSING
SHOULD ONLY BE OPENED BY AUTHORIZED AND QUALIFIED PERSONNEL, SUCH AS
AN ELECTRICAL TECHNICIAN.
i-DT61PW
1. Remove the six Phillips head screws from the rear housing.
2. Remove the front housing. Be careful not to disturb the internal connections.
TM Connector
TM
i-DT61XWE
i-DT61PW
connector to the terminal, plug the base's connector
EN-9