Introduction; Safety Precautions; Intended Use - OHAUS Defender 6000 Bedienungsanleitung

Defender 6000 Indicators

1. INTRODUCTION

This manual contains installation, operation and maintenance instructions for i-DT61PW and i-DT61XWE
indicators. Please read it completely before installation and operation.

1.1. Safety Precautions

Definition of Signal Warnings and Symbols
Safety notes are marked with signal words and warning symbols. These show safety issues and warnings.
Ignoring the safety notes may lead to personal injury, damage to the instrument, malfunctions and false results.
WARNING For a hazardous situation with medium risk, possibly resulting in severe injuries or
death if not avoided.
CAUTION For a hazardous situation with low risk, resulting in damage to the device or the
property or in loss of data, or minor or medium injuries if not avoided.
ATTENTION For important information about the product. May lead to equipment damage if not
avoided.
NOTE For useful information about the product.
Warning Symbols
General hazard
Safety Precautions
CAUTION: Read all safety warnings before installing, making connections, or servicing this equipment.
Failure to comply with these warnings could result in personal injury and/or property damage. Retain
all instructions for future reference.
Before connecting power, verify that the AC adapter's input voltage range and plug type are

compatible with the local AC mains power supply.
Do not position the equipment such that it is difficult to reach the power connection.

Only connect the power cord to a compatible grounded electrical outlet.

Make sure that the power cord does not pose a potential obstacle or tripping hazard.

Operate the equipment only under ambient conditions specified in these instructions.

The equipment is for indoor use only.

Do not operate the equipment in hazardous or unstable environments.

Do not place the equipment upside down on the platform.

Use only approved accessories and peripherals.

Disconnect the equipment from the power supply when cleaning.

Service should only be performed by authorized personnel.

WARNING: Never work in an environment subject to explosion hazards! The housing of the instrument
is not gas tight. (Explosion hazard due to spark formation, corrosion caused by the ingress of gases).
WARNING: Electrical shock hazards exist within the housing. The housing should only be opened by
authorized and qualified personnel. Remove all power connections to the unit before opening.

1.2. Intended Use

This instrument is intended for use in light industry. It must only be used for measuring the parameters
described in these operating instructions. Any other type of use and operation beyond the limits of technical
specifications, without written consent from OHAUS, is considered as not intended. This instrument complies
with current industry standards and the recognized safety regulations; however, it can constitute a hazard in
use. If the instrument is not used according to these operating instructions, the intended protection provided by
the instrument may be impaired.
Explosion hazard Electrical shock hazard
EN-3