Menu Settings; Menu Navigation; User Menu (In Segments); Maintenance - OHAUS Defender 3000 i-DT33P Bedienungsanleitung

EN-10

3. MENU SETTINGS

The User Menu allows the customizing of scale settings.
Note: additional sub-menus (USB, Ethernet and Print2 menus in the table below) may be available if interface
options are installed. See interface user manual for the additional setting information.
3.1.

Menu Navigation

3.1.1

User Menu (in segments)

C.A.L S.E.t.U.P r.E.A.d
ZErO reset reset
SpaN C.UNIt Stable
LINE rANGE ZErO
GEO CAP1 FIltEr
C.test Grad1 AZt
End CAP2 B.LIGHt
Grad2 b.COLOr
P.ZerO SCreeN
A.Off
P.UNIt
P.SAuEr
A.tare
End CEC
End
Notes:
Some modes/units may not be available in all models.
When LEGAL FOR TRADE is turned ON (the security switch is in the locked position), the menu settings will be
affected as below:

Calibration function is disabled.

Zero Range setting is locked at 2%.

Stable Range setting is locked at 1d.

Auto-Zero Tracking setting is locked at 0.5d.

Filter and Units are locked at their current settings.

Stable Only is locked at On.

:
Lb oz unit is locked at Off.

Power saving mode is disabled.

4. MAINTENANCE

CAUTION: DISCONNECT THE UNIT FROM THE POWER SUPPLY BEFORE CLEANING.
4.1.

Cleaning

For i-DT33P, the housing may be cleaned with a cloth dampened with a mild detergent if necessary.
For i-DT33XW, use approved cleaning solutions for the stainless-steel Indicator housing and rinse with water.
Dry thoroughly.
WARNING: Electric Shock Hazard. Disconnect the equipment from the power supply
before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
mM.O.d.E U.n.I.t R.s.2.3.2 P.r.I.N.t
reset reset reset
wWeIGH BAUd
kg
COUNt PArItY
g
CHECK StOP
lb
tOtAL H.SHAKE
oz
tABLE ALt.P
lb:oz
End ALt.t
t
ALt.Z
End
End
U.S.B E.t.H.N.E.t P.r.I.N.t2 L.o.c.k E.n.d
reset reset reset
ASSIGN BAUd IP.Addr
Stable PArItY u.E.r.
mMODE StOP ENd
tImME H.SHAKE
lINkto ALt.P
C.SUmM ALt.t
tEmMp ALt.Z
End ENd
Defender 3000 Indicators
reset reset
ASSIGN L.ALL
Stable L.OFF
mMODE L.ZErO
tImME L.PrINt
lINkto L.UNIt
C.SUmM L.mModE
tEmMp L.mMeNU
ENd L.tArE
End