Maintenance; Carbon Brushes; Check The Oil Level - Scheppach AB1600 Original Anleitungen

of 1.5 mm².
The mains supply is secured up to 16 A.
• The product meets the requirements of EN 61000-3-
11 and is subject to special connection conditions.
This means that use of the product at any freely se-
lectable connection point is not allowed.
• Given unfavorable conditions in the power supply the
product can cause the voltage to fluctuate temporarily.
• The product is intended solely for use at connection
points that
a) do not exceed a maximum permitted supply impe-
dance "Z", or
b) have a continuous current-carrying capacity of the
mains of at least 100 A per phase.
• As the user, you are required to ensure, in consultation
with your electric power company if necessary, that
the connection point at which you wish to operate the
product meets one of the two requirements, a) or b),
named above.

Maintenance

CLEANING
Caution! Disconnect the mains plug!
• Clean the machine each time after completing work.
• • The machine should be cleaned regularly to remove
dust and dirt.
• Keep safety devices, air vents and the motor housing
as dust and dirt-free as possible.
• Clean the device with a clean cloth, or blow it out
with compressed air at low pressure.
• All moving parts are to be re-greased at periodic in-
tervals.
• Do not use detergents or solvents as these might
damage the plastic parts of the device. Make sure
that no water can get inside the device.

CARBON BRUSHES

In case of excessive sparking, have the carbon brushes
checked by a qualified electrician.
Caution! The carbon brushes should be replaced only by
a qualified electrician.

CHECK THE OIL LEVEL

The oil level should be checked before each use of the
device.
Place the device with the tool holder in the down position
on the floor. The oil must be at least 4 mm above the
bottom edge of the sight glass. Refill oil, if required.
Oil change: Fig. 5
The oil should be changed after about 40-50 hours of
operation.
Recommended oil: 30 ml SAE 15W/40 or similar.
Caution! Switch off the device. Disconnect the mains plug!
1 Unscrew the sight glass (7) using the Allen wrench
(B) and drain the oil.
2 To prevent uncontrolled drainage of oil, place the
21