Checchi & Magli TRIUM Bedienungs- Und Wartungsanleitung Seite 59

Adjusting the flexible plate position
UN41-0614IN
For this operation, proceed as outlined below.
1) Loosen the wing nut (A).
2) Turn the lock lever (B).
3) Push the ploughshare forwards and turn it so it is
facing downwards.
4) Loosen the nut (C).
5) Turn the part (D) to position the flexible plate (F)
flush with the ploughshare (G) as shown in the fig-
ure.
Adjusting the row spacing
WARNING
Secure the work vehicle in position (lifted off the
ground) with external means (trestles, etc.).
Do not stand under the hoisted machine unless it is
suitably secured in position.
Adjust the gap between the transplanting units to ob-
tain the row spacing required (for distances envisaged,
see "Technical characteristics" schedule).
Keep the minimum distance stated on the illustration
between the seedlings and the tractor wheels.
English language
ADJUSTMENT INFORMATION
C
D
F
G
6) Tighten the nut (C).
7) Refit the share in the work position.
8) Check that the Plant Control device (E) is inside the
ploughshare.
9) Make sure that the ploughshare is secured in place
with the lock lever (B).
10) Tighten the wing nut (A).
Proceed as outlined below.
1) Lift the work vehicle slightly off the ground.
2) Loosen the nuts (A).
3) Slide the planting unit along the frame (B) until the
required planting spacing is obtained.
4) Tighten the nuts (A).
5) Adjust the planting units so that the seedlings are
kept (C) 10 - 12 cm away from tractor wheel.
17
5
Use and maintenance