Checchi & Magli PLASTIC-STOP PLUS Bedienungs- Und Wartungsanleitung Seite 74

- Adjusting the conveying disks
The conveying disks are used to convey the soil towards
the raised bed former in order to form the mound for the
seed bed or planting bed.
A
UN41 0271DI
To adjust the disk, proceed as outlined below.
1) Loosen the screws (A).
2) Raise or lower the disk to increase or decrease the
amount of soil needed to form the seedbed or plant-
ing bed.
3) Tighten the screws (A).
4) Loosen the screws (B).
5) Move the conveying disk unit as required.
6) Alter the inclination of the disks in order to spread
the soil properly to form the seed bed or planting
bed.
7) Tighten the screws (B).
Repeat the same procedure for the other disks.
- Adjusting the raised bed former
The raised bed former is used for pre-shaping the soil
before the shaping roller is used, in order to form a seed
bed or planting bed.
Adjust the raised bed former in order to accumulate
enough soil in front of the shaping roller to create the
furrow in the ground properly.
To adjust the raised bed former, proceed as outlined be-
low.
1) Adjust the tie rods (A) with an appropriate tool.
- Turn the tie rods clockwise to increase the amount of
soil in front of the shaping roller.
- Turn the tie rods anticlockwise to decrease the
amount of soil in front of the shaping roller.
English language
ENCLOSURES
A
B
UN41 0273DI
- Adjusting the shaping roller
The distance between the shaping roller and the ground
is set by adjusting the support wheel and it also deter-
mines the depth of the furrow in the raised seed bed or
planting bed (see page 4 "Technical Data").
UN41 0569CN
To adjust the shaping roller, proceed as outlined below.
1) Use the ratchet lever (A).
- Turn the lever in the direction (B) to increase the
shaping roller's height off the ground.
- Turn the lever in the direction (C) to decrease the
shaping roller's height off the ground.
Repeat the same procedure for the other support
wheel.
Information
After adjustment, check and if necessary readjust the
conveying disks and raised bed former.
34
A
B
A
Use and maintenance
A
C