Checchi & Magli PLASTIC-STOP PLUS Bedienungs- Und Wartungsanleitung Seite 63

- Strap up the unit at the lifting points envisaged by the
manufacturer.
- See the strap-up points and lifting procedures in the
sections titled "Lifting the work unit" on page 10.
- Lower the support feet onto the bed of the means of
transport.
- Anchor the work unit to the means of transport with
ropes and secure the wheels with wedges.
The work vehicle, coupled to the tractor, can be loaded
via ramps onto suitable means of transportation and
then transported.
UN41 0256IH
To load the work vehicle onto the means of transport,
proceed as follows.
1) Board the means of transport, as shown in the figure,
travelling at low speed.
2) Off the tractor engine and engage the parking
brake.
Transit on public roads
Danger - Warning
It is prohibited to carry people and/or things on the work vehicle.
Before embarking on the road, remove the mulch sheet roll from the work vehicle and clean any remaining
soil off the tyres and components.
A
UN41 0257IH
English language
INFORMATION FOR USE
Danger - Warning
Thoroughly clean the ramps and loading platform
before boarding the vehicle.
Position the ramps on the transport means and fix
them in a stable way to the truck bed using the fas-
tening devices (pins, screws, chain etc.).
Where the ramps meet the truck bed there is a dan-
gerous bump so move the machine very carefully
over this point.
3) Anchor the work unit-tractor assembly to the means
of transport with ropes and secure the wheels with
wedges.
4) Affix the relative signalling signs to any parts jutting
out from the means of transport.
23
6
Use and maintenance