Checchi & Magli PLASTIC-STOP PLUS Bedienungs- Und Wartungsanleitung Seite 58

- Adjusting the convergence
Alter the convergence of the pressure wheels to increase
or decrease the transverse tension of the plastic mulch
sheet.
To adjust the convergence, proceed as outlined below.
1) Loosen the screws (A).
2) Alter the angle of the wheel in relation to the longitu-
dinal axis of the work vehicle as required.
3) Tighten the screws (A).
- Adjusting the camber
Alter the camber to move the tyre away from the edge of
the plastic mulch sheet in small movements.
To adjust the camber, proceed as outlined below.
1) Loosen the screws (A).
2) Alter the wheel angle as required.
3) Tighten the screws (A).
- Adjusting the pressure of the wheels on the plastic mulch sheet
To adjust the wheel pressure, proceed as outlined be-
low.
1) Turn the handwheel (A) to increase or decrease the
wheel pressure on the plastic mulch sheet.
English language
ADJUSTMENT INFORMATION
UN41 0250 H
UN41 0251IH
UN41 0239IH
18
5
Use and maintenance