Checchi & Magli PLASTIC-STOP PLUS Bedienungs- Und Wartungsanleitung Seite 55

- Adjusting the depth, tilt, and longitudinal movement of the share
For adjustments, proceed as outlined below.
1) Loosen the screw (A).
- Raise or lower the share to increase or decrease the
amount of soil to ridge over the mulch sheet.
- Alter the angle of the share to increase or decrease
the width of the ridging over the sheet.
- Move the share closer to or away from the pressure
wheel to bring forward or delay the start of the ridg-
ing.
2) Tighten the screw (A).
If the pointer (C) prevents the share lowering as desired,
proceed as described.
1) Loosen the screw (B) and lift the pointer (C) without
turning it. The pointer must not be turned as it would
desynchronise the initial inclination of the share in
relation to the gauge scale (D).
2) Tighten the screw (A).
Repeat the same procedure for the other share.
Adjusting the hoeing disks
The hoeing disks are used to make furrows in the soil where the edges of the mulch sheet will be laid and are adjust-
able in terms of width, depth, and inclination.
UN41 0246IH
To adjust the hoeing disks, proceed as outlined below.
1) Loosen the nuts (A).
2) Place the disks at the distance from the edge of the
mulch sheet (C) shown in the figure.
3) Tighten the nuts (A).
English language
ADJUSTMENT INFORMATION
1÷2 cm
C
Adjust the disks as required, in the way described.
4) Loosen the screws (B).
5) Tighten the screws (B).
Repeat the same procedure for the other disk.
15
UN41 0245IH
1÷2 cm
- Raise or lower the disks to increase or decrease the
depth of the furrow.
- Alter the angle of the disks to increase or decrease
the width of the furrow.
5
Use and maintenance