Troubleshooting - Scheppach DECO-XLS Bedienungsanleitung

body for the disposal of waste electrical and electronic
equipment or your waste disposal company.

15. Troubleshooting

WARNING
Always switch the machine off and remove the mains
plug prior to all maintenance and cleaning work.
Fault Possible cause
Saw blade without Saw blade clamping screw (28/29) not
pins loosens after tightened enough
switching off the
engine
Motor does not start Failure mains fuse
Extension cable defect
Fine-wire fuse defective
Connections on the motor or switch defect
Motor or switch defect
Saw blades brake Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straightly
Saw blade oscillates, Holders not aligned
not aligned straightly.
30 | GB
Remedy
Tighten the saw blade clamping screw (28/29)
Check the mains fuse.
Change extension cable.
Check the fine-wire fuse and, if necessary,
replace it with a fine-wire fuse of the same type.
Have it checked by an electrician.
Have it checked by an electrician.
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the holders. Bring
the holders into the vertical position and tighten
the screws again.
www.scheppach.com