Panasonic ES‑EL9A Betriebsanleitung Seite 25

Problem
The appliance stops
during operation.
Cannot
remove hair.
The hair
becomes
stubble.
The appliance
is not
removing the
hair as well
as before.
Sensitive
area cap
comes off
during
operation.
The appliance
is not cutting
as well as
before.
PB018265 - ES-EL9A_EL7B
Possible cause
The appliance is
pressed against
skin too hard.
Not charged fully.
The appliance is
used on long hair.
The epilation head
surface is not
contacting to skin
closely.
The appliance is
not moved against
the flow of hair.
The appliance is
When
moved too fast.
epilating
Hair dust has
accumulated.
The skin protector
or discs are
deformed, cracked,
or damaged.
The appliance is
pressed against
skin too hard.
The appliance is
not applied at a 90°
angle to your skin.
Hair dust has
accumulated.
The blade is
deformed.
When
shaving
The blade is worn
out.
(01GB)_11-06-19.indd 25
Action
Contact to skin with
gentle force.
Fully charge the
appliance.
Use on hair
approximately 2 to
3 mm long.
Make the epilation
head surface contact
to skin closely and
move.
Move the appliance
against the flow of
hair.
(Refer to page 20.)
Move it slowly.
(Approximately
3~5 cm/sec)
(Refer to page 20.)
Clean the hair dust.
Request repair at an
authorized service
centre.
Contact to skin with
gentle force.
Apply at a 90° angle
to your skin.
(Refer to page 20.)
Clean the hair dust.
Replace the blade.
Guidelines for
replacement:
Outer foil:
Approximately 1 year
Inner blade:
Approximately 2
years
2019/11/6 9:49:35
25