Cleaning - Panasonic ES‑EL9A Betriebsanleitung

Tips for moving the foot care
head
Move in the direction indicated by
the arrows.
Use your free hand to support filing.
(Fig. 16)
Sonic scrub brush
ES-EL9A/ES-EL7B
• We recommend using about once
per week.
• We recommend using on areas for
epilation about 2 days before
actual epilation. Exfoliation may
help to prevent ingrown hairs.
1
1
Attach the brush head.
• Push down firmly until you hear
a "click".
2
2
Wet the sonic scrub brush.
(Fig. 17)
3
3
Apply shower gel to your skin.
4
4
Select the mode by pressing
the power switch [
5
5
Put the sonic scrub brush
onto your skin and begin
exfoliation. (Fig. 18)
• We recommend using on legs,
arms (especially elbows and
knees) and neckline.
Do not use on sensitive areas
of skin, face or throat.
• Do not continue to hold in one
place. Slide over skin in a
circular pattern.
• Apply to the same area of skin
for approximately 30 seconds
each time, check your skin and
adjust usage accordingly.
6
6
Press the power switch to
turn off the power.
• Moisturise by applying a
moisturiser that suits your skin
on the area where the sonic
scrub brush was used.
22
PB018265 - ES-EL9A_EL7B
K
e].
(01GB)_11-06-19.indd 22

Cleaning

• Always clean the heads and caps
after use to keep them in a
hygienic state.
• Switch off and unplug the
appliance before cleaning.
• Take care not to damage the skin
protector, the frame, the caps for
legs/arms and for underarms/
bikini‑line during cleaning.
Dry cleaning [
A B C D E F
Epilation head/Shaver head
1. Lift the caps and the frame
upward while holding the edge
of the cap [
A B C
the frame by pushing the frame
release button [
F
2. Clean the caps [
A B C
epilation head [
D
shaver head [ ] with the
F
cleaning brush [
M
Wet cleaning
[
A B C D E F H I J
Epilation head/Shaver head
(Fig. 21)
1. Wet the discs and blades, and
then apply liquid hand soap.
2. Turn the switch on and then
foam is created.
3. Wash the head with water to
wash out hair.
• Do not use hot water.
• If soap is not completely washed
away, then a white deposit can
accumulate and prevent the
discs and the blades from
moving smoothly.
• Rinse the shaver head with the
frame removed.
4. Turn the switch off, wipe the
appliance with a dry cloth and
dry it well.
]
] or remove
9]. (Fig. 19)
], the
] and the
]. (Fig. 20)
]
2019/11/6 9:49:34