Power; Battery Type; Low Battery Indication; Change The Battery - Cochlear Baha 6 Max Benutzerhandbuch

3. Power

3.1 Battery type

The Baha 6 Max Sound Processor uses a
312 size type hearing aid battery (1.45 Volt
zinc air, non-rechargeable). Batteries
should be replaced as needed, just as
you would with many other electronic
devices. Battery life will vary with e.g. daily
use, volume levels, wireless streaming,
sound environment, program setting, and
battery strength.

3.2 Low battery indication

If activated, the visual and audio signals
will alert you when there is approximately
one hour of battery power remaining
(at this time you may experience lower
amplification). If the battery runs down
completely, the sound processor will stop
working.
8

3.3 Change the battery

See figure 5
1. To replace the battery, remove your
sound processor from the head and
hold the sound processor with the
front facing down.
2. Gently open the battery door until it is
completely open.
3. Remove the old battery and dispose
of it according to local regulations.
4. Remove the new battery from the
packet and peel away the sticker on
the + side.
5. Insert the battery into the battery
compartment with the + side
facing up.
6. Gently close the battery door.
WARNING
Batteries can be harmful if swallowed.
Be sure to keep your batteries out
of reach of small children and other
recipients in need of supervision. In
the event a battery is accidentally
swallowed, seek immediate medical
attention at the nearest emergency
centre.