Fault And System Messages - WIKA CPH6200-S1 Betriebsanleitung

Hand-Held Pressure Indicator
CPH6200-S1 / CPH6200-S2
GB
22

6. Fault and system messages

Display Meaning
Low battery power, device will only work
for a short while longer
Battery flat
Mains operation without battery: wrong
voltage
SEnS
No sensor connected
Erro
Connected sensor or device faulty
Value extremely out of measuring range
or Err.9
- - - -
Logger data is being read by the serial
interface
- - - -
No display Battery flat
or strange
Mains operation without battery: wrong
symbols,
voltage or polarity
device is not
System error
responding to
input
Instrument faulty
Err.1
Measured value above allowable range
Sensor faulty
Err.2
Measured value below allowable range
Sensor defective
Err.3
Display range overflow
Err.4
Display range underflow
Err.7
System error
Err.11
Value coul not be calculated
Calculation overflow happened
WIKA Operating Instructions Hand-Held Pressure Indicator
Remedy
Replace battery
Replace battery
Check power supply, change it if
necessary
Switch off device and connect sensor
If second sensor available, check if de-
vice is ok. Return defective device/sen-
sor to manufacturer for repair
Check: pressure not within sensor
range?
When the data transfer is completed
the device will automatically return to
normal measuring display, no remedy
necessary
Replace battery
Check power supply, change it if
necessary
Disconnect battery or power supply,
wait a while, re-connect
Return to manufacturer for repair
Check: Is the pressure outside the sen-
sor's range? -> measured value to high!
Return to manufacturer for repair
Check: Is the pressure outside the sen-
sor's range? -> measured value to low!
Return to manufacturer for repair
Check: value above 9999 -> to high to
be displayed!
Check: value below ‚-2000' (Tare?) ->
to low!
Return to manufacturer for repair
Choose different unit
Choose different unit